[cctalk] Re: Formatting and using RQDX3's and 2190's.

Ok. Hm. So the command would be ./mfm_write --emulation RD54_A -d3? This is possibly better than nothing: I could use this to put some sort of format on the drive, then try letting xxdp reformat it. Right now I'm getting this: DR>START CHANGE HW (L) ? Y # UNITS (D) ? 1 UNIT 0 Enter controller IP Address (O) 172150 ? What unit do you want to format [0-255] (D) 0 ? Would you like to revector a single LBN only [Y/N] (L) N ? Do you want to use the "AUTOFORMAT" Mode [Y/N] (L) Y ? Enter unit serial number [1-32000] (D) 12345 ? **** WARNING **** ALL DATA ON SELECTED DRIVE WILL BE DESTROYED Write protect all drives not being formatted. Please verify that the selected drive is ON LINE and NOT write protected. If formatting RX33 media, insert media to be formatted in the selected drive. Do you wish to continue [Y/N] (L) Y ? Y Autosizer found: Unit Cylinders Drive Name 0 1225 RD54 1 RX33 Diskette (FORMATABLE) MSCP Controller Model: 19 Microcode Version: 1 Formatting of Drive 0 Begun. (Oddly enough the old controller doesn't display the progress. I really think it's just talking to the RQDX3 and that is calling the shots as the later ROMs do tell you how far it is and what it's doing which is nice) ZRQC SYS FTL ERR 00007 ON UNIT 00 TST 001 SUB 000 PC: 105742 Controller has reported a fatal error in the FORMAT program. Status: RCT write error Drive 0 was not formatted successfully. ZRQC EOP 1 1 TOTAL ERRS