Advice on Desoldering an IC

Mike Katz bitwiz at 12bitsbest.com
Fri Apr 15 13:08:10 CDT 2022


I have to second this comment.

I learned to solder in the early 70s building kits and again 
professionally in the early 80s.

In the early days of thicker circuit boards (2 layer only).  A solder 
sucker and solder wick would work.

However, the most expedient and safest way in terms of potential board 
damage, is to cut out the bad chip, then take the pins out one at a time 
and then suck and wick out the holes.

This presents the smallest risk of damaging traces or the plating inside 
the holes.

On 4/15/2022 12:51 PM, Chris Zach via cctalk wrote:
> Cut the pins with a very sharp set of dykes then remove them one at a time. Then use flux and detailer braid to remove the solder
>
> On April 15, 2022 1:49:33 PM EDT, Rob Jarratt via cctalk <cctalk at classiccmp.org> wrote:
>> I am trying to remove an IC from my PDP 11/24 CPU, a DS8641. I am really
>> struggling to desolder it. I am using the technique of applying fresh solder
>> and then removing it. But after multiple cycles of this I think I am
>> starting to damage the PCB.
>>
>>
>>
>> I am using a fairly cheap desoldering station (this one
>> https://cpc.farnell.com/duratool/d00672/desoldering-station-uk-eu-plug/dp/SD
>> 01384?st=duratool%20desoldering). Its spec in terms of vacuum pressure is
>> equivalent to that of the professional Hakko ones though. I am also trying a
>> hand desoldering pump. None of these are able to clear many of the holes of
>> solder, although some are doing better than others. Nevertheless, the IC
>> remains stubbornly unmoving.
>>
>>
>>
>> Are there any tips for removing ICs?
>>
>>
>>
>> Thanks
>>
>>
>>
>> Rob
>>



More information about the cctech mailing list