PDP-11/70 Boards

[Jay Jaeger]

On 11/30/2021 3:52 PM, Henk Gooijen via cctalk wrote:
> Van: Fritz Mueller via cctalk<mailto:cctalk at classiccmp.org>
> Verzonden: dinsdag 30 november 2021 22:43
> Aan: General Discussion: On-Topic and Off-Topic Posts<mailto:cctalk at classiccmp.org>
> Onderwerp: Re: PDP-11/70 Boards
> 
> 
>> I built mine from a layout on Tom Uban’s site: http://www.ubanproductions.com/museum.html
> 
>> Did you use that directly with ExpressPCB and order from ExpressPCB or did you convert to more standard gerbers?
> 
> I just went with ExpressPCB for minimal hassle, but you could probably get it cheaper from other board houses these days.  For my KB11-A + FP11-B, which run asynchronously, it was handy to build up two of these.  Also useful for the RK11-C.
> 
>    —FritzM.
> 
> And useful for PDP-11/05, PDP-11/10, PDP-11/20, PDP-11/35, PDP-11/40 … more?
> Henk, PA8PDP
> 

The issue is (I think) that the ExpressPCB software can only be used to 
create files to order boards from them - or can it now export ordinary 
gerbers?  (Otherwise, to go with another fab. I presumably would 
re-enter the schematic, and re-route it - granted not all *that* hard, 
but still a day's work.

JRJ