PDP-11/70 debugging advice

Guy Sotomayor ggs at shiresoft.com
Sun Jan 31 16:38:52 CST 2021


Did you check to make sure that power is wired correctly to the 
PEP-70/Hypercache?  They are typically installed in "empty" slots and 
don't have power (or anything else) routed to them.  They require some 
additional jumpers to be installed on the backplane so that they get power.


On 1/31/21 2:31 PM, Josh Dersch via cctalk wrote:
> Hi all --
>
> Making some progress with the "fire sale" PDP-11/70. Over the past month
> I've rebuilt the power supplies and burned them in on the bench, and I've
> gotten things cleaned up and reassembled.  I'm still waiting on some new
> chassis fans but my curiosity overwhelmed my caution and I decided to power
> it up for a short time (like 30 seconds) just to see what happens.  Good
> news: no smoke or fire.  Voltages look good (need a tiny bit of adjustment
> yet) and AC LO and DC LO looked good everywhere I tested them.  Bad news:
> processor is almost entirely unresponsive; comes up with the RUN and MASTER
> lights on, toggling Halt, and hitting Start causes the RUN light to go out,
> but that's the only response I get from the console.
>
> I got out the KM11 boardset and with that installed I can step through
> microinstructions and it's definitely executing them, and seems to be
> following the flow diagrams in the engineering drawings.  Left to its own
> devices, however, the processor doesn't seem to be executing
> microinstructions at all, it's stuck at uAddress 200.
>
> In the troubleshooting section of the 11/70 service docs (diagram on p.
> 5-16) it states:
>
> IF LOAD ADRS DOES NOT WORK AND:
> - RUN, MASTER & ALL DATA INDICATORS ARE ON
> - uADRS = 200 (ZAP)
> THEN MEMORY HAS LOST POWER
>
> Which seems to adequately describe the symptoms I'm seeing, but as far as I
> can tell the AC and DC LO signals are all fine.  (This system has a Setasi
> PEP70/Hypercache installed, so there's no separate memory chassis to worry
> about.)  I'm going to go back and re-check everything, but I was curious if
> anyone knows whether loss of AC or DC would prevent the processor from
> executing microcode -- from everything I understand it should cause a trap,
> and I don't see anything in the docs about inhibiting microcode execution.
> But perhaps if this happens at power-up things behave differently?  And the
> fact that the troubleshooting flowchart calls out these exact symptoms
> would seem to indicate that this is expected.  But I'm curious why the KM11
> can step the processor, in this case.
>
> I'm going to wait until the new fans arrive (hopefully tomorrow or tuesday)
> before I poke at this again, just looking for advice here on the off chance
> anyone's seen this behavior before.
>
> Thanks as always!
> - Josh

-- 
TTFN - Guy



More information about the cctech mailing list