Testing a H744 Regulator on The Bench

Jonathan Chapman lists at glitchwrks.com
Thu Dec 30 15:32:30 CST 2021


Sounds like you're testing things basically the way I was:

http://www.glitchwrks.com/2019/06/05/pdp1110-psu-repair

I used a large Stancor 24 VAC transformer to supply power to the modules, since they usually see 20-30 VAC from the big transformer in the chassis.

For dummy loads, I like automotive tail lamp bulbs. Series/parallel as necessary to get the load you want. Do keep in mind they get hot enough at rated voltage to melt soft plastics.

> I replaced them with a LED and a resistor.

Many of the later modules do that anyway! I used incandescent lamps because I had them on hand. Wouldn't you know, after reassembling and a few hours of bench running in the PDP-11/10, one of the old ones I hadn't replaced burned out too :P

Thanks,
Jonathan


More information about the cctech mailing list