RK11-C indicator panel inlays?

[David Bridgham]

On 12/6/21 17:45, Mike Katz wrote:

> If I may8 ask a question.  I have never had boards made before. How do 
> I find a good board house that is reasonable and how do I specify the 
> board especially for the PDP-8 Omnibus which should have gold fingers 
> on the edge connectors?


I was planning to try PCBWay for my boards. They say they do hard gold 
fingers and they have a board assembly option that looks like it can do 
what I need. I haven't used them before so this will be an experiment in 
that direction as well.

If you're using KiCad for your designs (and if the Omnibus uses the 
standard DEC boards), I have templates for double and quad height  
boards that you're welcome to. Since I haven't yet made boards from 
them, check yourself that they're right before ordering but at least 
they'd be a start.

Dave