removing melting rubber from metal?

[Kelly Fergason]

Hi All,

I have an EP-1 eprom programmer from BP Microsystems.

The rubber feet melted.  It was in my closet.  I have no clue how it got
that hot, or if they
are just some composition for them to melt.

My question is how do I clean this up?  Acetone, paint thinner?  I scraped
off the feet, so there is
just a few 'streams' of melted rubber down the sides, and a bit that
somehow got inside (also on the side, not on the electronics).

Just looking for some ideas before I start applying chemicals...

Thanks,
Kelly