Intermec 8625 printer

[nico de jong]

Hi all,

I'm hoping to get an answer here.

The 8625 barcode printer has a prompting mode, switched on by activating 
the bottom switch in a bank of switches. The printer is then supposed to 
write a prompt, so you can start programming the label formats.

I seem to remember that the printer expects a CTRL+H sequence to be 
reset/restarted, but nothing happens.

Can any of you remember the settings for the terminal (I do know about 
9600,7,1,even) ? I'm not sure on which terminal the printer expects to 
write to. VT100 ? ANSI? ? And how about flow control?

Any help would be appreciated

Regards

Nico

PS The printer is to be used for museum purposes, and as usual, the 
museum has no money to spend :-(