Looking for two DEC H445 power bricks for PDP 11/40 project

[Paul Anderson]

I grabbed a 11/60, 11/35 system manual. wanting to see hot power was set up
in the BA11-D and -K, only to find it dealt with the BA11-F only.

It does state the H754 in used with the MF11-U/UP. needless to say, there
are different plugs for slot "E" and possibly a change or a jumper.

I will look for a 11/35 book specifically next time I go downstairs.

My 11/40 does have 2 H745s in it. I see no reason to use both at this
point. I think one can supply enough current unless you overload it with a
bunch of 8K core.

I plan on putting either 8 16K core stacks in(for winter only) or an
MS11-LD (256KB).

Pierre, a lot of my bricks are buried. I'll try to did them out tomorrow.

Thanks, Paul

On Wed, Sep 19, 2018 at 4:09 PM, Eric Smith via cctalk <
cctalk at classiccmp.org> wrote:

> On Tue, Sep 18, 2018 at 8:27 AM, Noel Chiappa via cctalk <
> cctalk at classiccmp.org> wrote:
>
> > (Note that if you have an old
> > machine/harness, there's a jumper you have to add if you have only a
> single
> > H745; see the second paragraph on page 6-18 of DEC-11-H40SA-B-D.)
> >
>
> I totally missed that. It wasn't in the previous edition, DEC-11-H40SA-A-D.
>
> However, now I see that both editions mention that the H744 in slot C is
> optional, which I also was not previously aware of.
>
> Although I've had a few 11/40 machines, I didn't often have to do anything
> about the power supplies other than check the DC voltage and ripple.
>