Need help reproducing a PCB

[Anders Nelson]

Hey Jim,

I can probably do this for you but I'm pretty busy for the moment. What's
your desired timeline? I've been using EAGLE since 2005 so I'm familiar.

=]

--
Anders Nelson

+1 (517) 775-6129

www.erogear.com

On Wed, May 10, 2017 at 8:23 AM, Doug Ingraham via cctalk <
cctalk at classiccmp.org> wrote:

> If this is a one off all you need to do is print the negatives on
> transparency material with a laser printer.
> The laser printers tend to have a little more opacity than ink jets do but
> I have done this with an ink jet
> printer as well.  I also once plotted directly on the bare copper with a
> sharpie and had it turn out ok.
>
> Align the negatives on the sensitized board stock.
> Expose.
> Develop.
> Etch.
> Drill
> Solder in your feed throughs.
> Put the parts on the board.
> Debug
>
> If on the other hand you want to make even 5 boards you would be better off
> with your approach.
>
> Best wishes!
>
> --
> Doug Ingraham
> PDP-8 SN 1175
>