Suggestions why SCSI 80 drive w/ SCSI2 (50) adapter will not spin up ?

[Pete Lancashire]

Found at least one issue, open trace next to a via on the adapter. Ran out
of time to keep checking.

-pete

On Tue, Mar 21, 2017 at 4:10 AM, Rik Bos via cctalk <cctalk at classiccmp.org>
wrote:

> The HP 9000/382 only supports SE scsi and the drive needs to be terminated.
>
> -Rik
>
> Van: Pete Lancashire via cctalk
> Verzonden: dinsdag 21 maart 2017 07:17
> Aan: General
> Onderwerp: Suggestions why SCSI 80 drive w/ SCSI2 (50) adapter will not
> spin up ?
>
> Host is a HP 9000/382
>
> Copied the orig drive using a linux box, adaptec 2940N and good old dd
>
> Then swapped drives, a unused 9 GB 80 pin with a Chinese 80 to 50
> adapter.
>
> Did have to issue a spin up command and then copied the data to this drive
> again with dd.
>
> Powered all off, added a motor start jumper to the adapter and put it on
> the
> 9000/382. Motor will not start, added a jumper right on the drive, no spin.
>
> so .. any ideas what I'm doing wrong, or just try a different drive ?
>
> -pete
>
>
>