MEM11A update

[Pete Lancashire]

I've never used EagleCAD but some CAD packages let you turn off all routed
lines



On Tue, Mar 29, 2016 at 5:25 PM, Paul Koning <paulkoning at comcast.net> wrote:

>
> > On Mar 29, 2016, at 8:18 PM, Guy Sotomayor <ggs at shiresoft.com> wrote:
> >
> > I just finished laying out the board for the MEM11A.  The last roadblock
> was figuring out
> > where the last 3 unrouted wires were.  EagleCAD didn’t make it easy to
> find them and I
> > haven’t quite figured out how to use the autorouter on Eagle 7.5, so I
> did this all by “hand”
> > (at just under 2000 wires it took a while).
>
> I can imagine.  Hand-routing tends to produce much better results; the
> autorouter in EagleCAD isn't all that good.  A simple way to find the not
> yet routed wires is to turn off the metal layers but leave the "ratsnest"
> layer visible.
>
>         paul
>
>
>
>