Olivetti M24 Mounting Bushes for Bus Converter

[Robert Jarratt]

> -----Original Message-----
> From: cctalk [mailto:cctalk-bounces at classiccmp.org] On Behalf Of tony
duell
> Sent: 25 March 2016 12:59
> To: General Discussion: On-Topic and Off-Topic Posts
> <cctalk at classiccmp.org>
> Subject: RE: Olivetti M24 Mounting Bushes for Bus Converter
> 
> 
> > > Could they be 3d printed? Pictures might help...
> >
> > There are actually two varieties. The plastic ones probably could, but
> > actually I was  talking about the steel ones which probably can't. I
> > have put it all away again for now so I can't get any pictures right
> > now. I'll get it out again later, if I can, and post some pics.
> 
> Could you turn them on a lathe. I assume they're quite small.
> 
> -tony
> =

Perhaps, if I had a lathe. I do have a locksmith friend who could possibly
make them, but it is the way they go into the base that is problematic. I
will have to post some pictures.

Regards

Rob