VR241 Stray Wire

[Rob Jarratt]

> -----Original Message-----
> From: cctalk [mailto:cctalk-bounces at classiccmp.org] On Behalf Of tony
duell
> Sent: 25 June 2016 16:49
> To: rob at jarratt.me.uk; General Discussion: On-Topic and Off-Topic Posts
> <cctalk at classiccmp.org>
> Subject: RE: VR241 Stray Wire
> 
> > You can see the wire in question at the bottom of the picture below,
> > it is the green wire with a single-pin connector on it, and the size
> > link connector is the two-pronged connector just below it in the photo:
> >
> > https://1drv.ms/i/s!AlQc3lJwQx7bgbAJQx-HsvGY8Gcqsg
> >
> > Anyone know where this wire should go?
> 
> I believe you have 'my' schematic of the VR241. I think this wire is shown
on
> sheet 2 of the scan board diagram, (page
> 7 of the .pdf file) just above C718. It's on the daughterboard that
carries the
> horizontal output transistor, and is fitted onto one of 2 pins on that
board
> labelled 'S' and 'L'. In one position it does nothing (so leaving it free
would do
> no harm provided it doesn't short to anything), in the other is
short-circuits
> C718.
> 


Yes I have your schematic and I had looked to see if I could see the wire
but I had failed to spot it. Thanks for pointing it out. My worry was simply
that I had not noted where it connected, but it seems it wasn't connected in
the first place.

Regards

Rob