DL11 M7800

[william degnan]

OK.  I must be missing something here

Does anyone have a M7800 (DL11) set for 9600 b N71 or N81 jumper'd with the
default address for use as a serial terminal interface?  I understand the
other jumpers on the card, but the address and vector jumpers confuse me.
I can't seem to find a table or a "here is the default for console" or I
don't get it. I have the manual, I want I believe 777560, but I cannot find
"table 5-2" referred to in my copy of the manual.  Can someone give me a
couple of examples "if you have Ax Ay Az connected then that represents
address ------- .

I am looking at the manual and web sites on the subject and I think for use
as a simple serial terminal interface I need to jumper "in" *A9, A7, A5,
A4, A3* ... correct?  Vector jumpers *V6, V7 "*in" .  Just curious if
anyone can help me specifically not indirectly what I need, super thanks in
advance.

Thanks
Bill

-- 
@ BillDeg:
Web: vintagecomputer.net
Twitter: @billdeg <https://twitter.com/billdeg>
Youtube: @billdeg <https://www.youtube.com/user/billdeg>
Unauthorized Bio <http://www.vintagecomputer.net/readme.cfm>