IBM 360/30 in verilog

Camiel Vanderhoeven iamcamiel at gmail.com
Tue Jul 12 03:55:56 CDT 2016


Op 12 jul. 2016 10:14 a.m. schreef "Dave Wade" <dave.g4ugm at gmail.com>:
>
> > -----Original Message-----
> > From: cctalk [mailto:cctalk-bounces at classiccmp.org] On Behalf Of Curious
> > Marc
> > Sent: 12 July 2016 08:58
> > To: General Discussion: On-Topic and Off-Topic Posts
> > <cctalk at classiccmp.org>
> > Subject: Re: IBM 360/30 in verilog
> >
> > Darn. My hopes are shattered. Lots of Verilog in my future, that is if
we
> can
> > find 360/50 ALDs...
> > Marc
> >
>
> It actually might be easier to produce a generic S/360 clone in FPGA using
> the POP rather than individual ALU's.
> Having built a very simple CPU (in VHDL not Verilog) and planning to start
> on a more complex (Ferranti Pegasus)
> Of course it wouldn't be cycle accurate, but perhaps that wouldn't be
> important.

Sure, a generic one would be simpler, but the point of doing an accurate
one of a specific model (65 in my case) is to accurately drive the panel
that shows the  internal registers and opening of gates.


More information about the cctech mailing list