ASCI u68 (SystemX)

[Brad]

Thanks Henk,

I tried that.  No prompt comes up with PUTTY on serial set at any baud rate.    Instead on the LED display I get a C, or an S sometimes.

-----Original Message-----
From: cctalk [mailto:cctalk-bounces at classiccmp.org] On Behalf Of Henk Gooijen
Sent: Friday, October 16, 2015 11:56 AM
To: General Discussion: On-Topic and Off-Topic Posts <cctalk at classiccmp.org>
Subject: Re: ASCI u68 (SystemX)

-----Oorspronkelijk bericht-----
From: Brad
Sent: Friday, October 16, 2015 8:27 PM
To: 'General Discussion: On-Topic and Off-Topic Posts'
Subject: RE: ASCI u68 (SystemX)

Many thanks.  I'll take a quick look online just to see if I can save you the trouble.  I'm surprised at how little documentation there is for this thing.

As a general rule, does anyone know -- if you have a single board computer like this with serial connector, is that 'live' all the time?  Or do you usually have to invoke a program in order for a terminal to connect to it and use it?

---------
>From all the SBCs that I know, the standard serial port is always active. The on-board monitor with very basic commands uses it as only means of communication.
After reset the monitor will "print" possible a one-line identification and on the next line some form of prompt.
Could be * or .  or > or - or whatever.

You need to know the com ports settings, but it prints an ID line you can try several baudrates. 9600 is a good start.

If you want 6800 info, ask. I can dream 6800 opcodes!
INX=$08, LDA # =$86, DEX=$09, STAindexed =$A6. etc.
Depending on the RAM size, I have a StarTrek version in 6800 assembler that uses a serial port ... IIRC, it is some 1.5k

- Henk 

-----
No virus found in this message.
Checked by AVG - www.avg.com
Version: 2015.0.6172 / Virus Database: 4447/10805 - Release Date: 10/12/15