H960 logo panel

[Paul Anderson]

I might have prints for the rk11, and RK11 and RF11 on fische, when I can
find them

On Tue, Oct 13, 2015 at 1:48 PM, Noel Chiappa <jnc at mercury.lcs.mit.edu>
wrote:

>     > From: Henk Gooijen
>
>     > I will probably download everything ... in my experience, websites
>     > with "/~xxxx/" in it seem to disappear after "some" time :-/
>
> True, but pages maintained by institutions are almost equally bad about
> staying put! Many's the time I've clicked on a link, and the target's
> gone...
>
> I make a real effort to try and not not kill any URL to my Web site that
> ever
> worked (via redirects, if needed). I wish institutions were the same, but
> alas, for most Web-masters, they apparently seem not to give a rodent's
> posterior.
>
> But the downloading is a good idea - the more copies, the better (although
> in
> this particular case, it's not like the content is irreplacable).
>
>
>     > I have probably all PDP-11 models (except the PDP-11/50)
>     > ...
>     > I am not going to disassemble just for a scan.
>
> Well, the /45 front panel is easy: take out the 4 screws holding the bezel
> on
> (quite easy - unlike, say, removing an H7420 to clean it - something I am
> probably going to have to do), and then take out the 3 counter-sunk screws
> holding the panel on (ditto), remove the two knobs (ditto again) - done!
> And
> equally easy to reverse the process.
>
>     > I could take pictures, but as you say, edges will warp a little.
>
> We've already got pretty good pictures of the 11/45 panel, and the RP11-C.
> There are no RF11 or RK11-C images (that I know of - the RF11 manual only
> has
> a drawing, and the RK11-C manual, not even that), so if you have either of
> those, a picture would be better than nothing.
>
>         Noel
>