RL01/02 spindle ground brushes

[Paul Anderson]

Thanks for the info.

Paul

On Tue, Mar 3, 2015 at 7:29 PM, Paul Koning <paulkoning at comcast.net> wrote:

>
> > On Mar 3, 2015, at 8:24 PM, Mark J. Blair <nf6x at nf6x.net> wrote:
> >
> >
> >> On Mar 3, 2015, at 16:56 , Paul Anderson <useddec at gmail.com> wrote:
> >>
> >> Do you have a good source for graphite rod?  I'm looking for some for
> >> another project.
> >
> > McMaster-Carr carries graphite rod stock.
>
> So does Enco (use-enco.com), which often is less expensive (but doesn’t
> have quite the enormous selection of stuff that McMaster-Carr does).  They
> call it “EDM Rod” because these rods are used for the tool bits in electric
> discharge machines.
>
>         paul
>
>