RA81 removal

Johnny Billquist bqt at update.uu.se
Mon Jan 26 07:45:47 CST 2015


On 2015-01-26 01:00, Noel Chiappa wrote:
>      > From: Johnny Billquist
>
>      > You mean sliding them out on their rails or removing them from the
>      > rails?
>
> Sliding them out on their rails. (Removing them from their rails I've figured
> out how to do! :-)

Ok. Normally they should slide out without any fuzz at all. However, 
occasionally I've seen them secured in place by a bracket at the rear.

And, while I haven't seen this explicitly on RA81s, there are sometimes 
a design with a spring latch on the top right, that needs to be pushed 
in with a finger before a box can slide out. But I can't see that they 
would have re-fitted your drives with that. I would start by checking if 
they were secured with a bracket at the rear.

And of course, you then have some additional small locks and tricks if 
you want to extend them beyond their normal point, as needed if you 
actually plan to remove them from the slides.

	Johnny



More information about the cctech mailing list