11/23 clock issue

Tothwolf tothwolf at concentric.net
Sat Feb 7 13:20:31 CST 2015


On Sat, 7 Feb 2015, Noel Chiappa wrote:

>    > From: Tothwolf
>
>    > Before I forget again, did you check for +5V on pin 1 (enable) when
>    > you were testing your existing oscillator?
>
> Wow. Never thought to try that. Then again, I don't look for +5V on your 
> average 74xxx when I'm debugging, either! :-) I mean, it's a trace, the 
> solder on the pin looks good, that's as far as I go, usually! And 
> there's nothing shown as connected to that pin on the circuit diagram.
>
> So I looked, and... it's at ground (or floating). The only pin that has 
> anything is 14, at +5V (expected). But I looked online for some 
> datasheets for similar oscillators, and some of them say 'pin 1 - N/C'. 
> Are yours tri-state? (That's the enable pin on the tri-state ones.)
>
> I suppose even if yours are tri-state, I can still use them; a quick 
> ohmmeter check shows that pin 1 isn't connected to either power or 
> ground, so I can probably tie it high (via a resistor, which in addition 
> to being normal practise, will prevent a major disaster in case I'm 
> confused - a state I'm often in :-).

According to the datasheets, the parts I have use pin 1 as the enable pin, 
so I assume they are. I've included links to the two datasheets in the 
reply I sent you off-list. I usually just see pin 1 tied directly to 14 on 
a lot of boards when these type of oscillators are used so I don't know 
that you would even need a resistor there, just a mod wire would likely 
suffice.


More information about the cctech mailing list