11/23 clock issue

Holm Tiffe holm at freibergnet.de
Fri Feb 6 01:44:05 CST 2015


Noel Chiappa wrote:

>     > From: Brent Hilpert
> 
>     > Well, try removing W1 to isolate the output of the xtal oscillator E15
>     > from inverter input pin E4.4.
> 
> Thanks! Too late to try it today, but first thing tomorrow..
> 
> It seems like every time you answer one of my queries, I smack my forehead
> and say 'That's an excellent idea! Why didn't _I_ think of that!?!?' :-)

Hmm, may be since his hints are standard debugging technique and you aren't
really familiar with debugging??
> 
>     > If you're not familiar with them, E15 is an integrated xtal oscillator,
>     > not just a crystal - the crystal and oscillator logic are both in that
>     > can
> 
> I'm not familiar, so thanks for the tip. Wonder where I'll find one if that's
> what's bad... :-)
> 
>     > Could also (with W1 removed) pull E4.4 hi/lo while watching the
>     > inverter output E4.16 to see if it responds correctly with the
>     > inversion.
> 
> Since it's a tri-state, I may need to hit the enable somehow. Oh, wait, I
> see, it's hard-wired on via a pull-down. (I wonder why they needed a
> pull-down? And I wonder what the test point is there for?) And I guess I need
> like a 5K series pull-up resistor to +5, right? (Ground I can just tie
> directly, right?)
> 
> Anyway, thanks again for the help - very, very useful.
> 
> 	Noel

You don't ned no pullup for +5. All open TTL inputs are reading High w/o
any pullup.

Regards,

Holm

-- 
      Technik Service u. Handel Tiffe, www.tsht.de, Holm Tiffe, 
     Freiberger Straße 42, 09600 Oberschöna, USt-Id: DE253710583
  www.tsht.de, info at tsht.de, Fax +49 3731 74200, Mobil: 0172 8790 741



More information about the cctech mailing list