Data I/O 29B

[wulfman]

i got a few of them and have the data somewhere i will try to dig it up
and send u off list


On 8/21/2015 5:33 PM, Billy Pettit wrote:
> I have a small batch of Data I/O EPROM burners.  Trying to test them out and ran into a nightmare.  They require a pin family and size parameter.  But in none of the documentation is there any mention of what these values are.  There are some generic pinouts, which are almost useless because Data I/O changed the definition of several pins.
>
> Then the manual says to get your part's timing chart and compare them to 409 pages of timing charts to find the family type!  Nothing is mentioned anywhere on how to calculate size parameter.
>
> There should be a chart or document somewhere that gives the parameters by model numbers like 2516, 2764, etc.
>
> Anyone know of a document like this?
>
> Anyone have experience with the model 29A&B, Model 19, Model 100 gang programmer, etc.
>
> At this point, without better data, these 11 -12 deveces are heading for the scrap pile.  This is the poorest documentation I've ever seen on a piece of test equipment.
>
> Billy Pettit
>
>


-- 
The contents of this e-mail and any attachments are intended solely for the use of the named
addressee(s) and may contain confidential and/or privileged information. Any unauthorized use,
copying, disclosure, or distribution of the contents of this e-mail is strictly prohibited by
the sender and may be unlawful. If you are not the intended recipient, please notify the sender
immediately and delete this e-mail.