Fanuc PPR - Paper Tape Punch, Printer and Reader : Not quite working

Chuck Guzis cclist at sydex.com
Sat Apr 9 21:28:53 CDT 2022


On 4/9/22 17:26, Martin Bishop via cctalk wrote:
> Bill
> 
> Thanks for the offer of the DosTek 440a.  However, my problem is getting the 232 output to wiggle a CRO not to input and log the serial data.
> 
> Fanuc manuals 1788.pdf, on VintageComputer.net, looks as though it contains more detail than the PPR and System P manuals and may reward study.
> 

Are you certain that the interface isn't wired for current loop?  A lot
of these CNC (I'm assuming that this Fanuc unit falls in that category)
used the CL interface.  Connector's the D-25.

--Chuck



More information about the cctalk mailing list