DECNet for Pro 300 series boxes

Rob Jarratt robert.jarratt at ntlworld.com
Mon May 17 14:24:02 CDT 2021


Not aware of any, however if there is a C compiler for the Pro 300 series then you could potentially adapt my user mode router to the Pro 300. In fact, it might be a fun project. However, it isn't the full DECnet stack, just the router and a little bit of the Network Management layer. I am trying to repair my real Pro 350, although I am not having much luck so far.

Regards

Rob

> -----Original Message-----
> From: cctalk <cctalk-bounces at classiccmp.org> On Behalf Of Bob Smith via
> cctalk
> Sent: 17 May 2021 19:43
> To: General Discussion: On-Topic and Off-Topic Posts
> <cctalk at classiccmp.org>
> Subject: DECNet for Pro 300 series boxes
> 
> My recollection of Decnet for Pro boxes is that the available SW was for an
> end node and not a routing or other capability for the
> 380/350/325 boxes.
> While that memory might be incorrect, are there any DecNet packages for
> the Pro family available anywhere?
> a few hours of searching did not turn up any thing but PDFs about the
> software.
> thanks in advance for any replies.
> bob



More information about the cctalk mailing list