Maxtor ESDI drive PCB question

[Kurt Nowak]

Sorry, typo... they are XT-8760E drives.

On Sun, May 9, 2021 at 9:12 AM Kurt Nowak <knowak at alumni.calpoly.edu> wrote:

> Hi All,
>
> I have two Maxtor XT-4380E drives, one is a Series Code 3 and the other is
> 4. Is it OK to swap the boards between the two or is this a bad idea? They
> physically appear to look the same.
>
> Also a general question about PCB cleanup. Is there a method or solvent of
> some sort to clean boards? I've always used 99% alcohol in the past.
>
> -Kurt
>