Connecting SIMH to teletype via USB

Charles charlesmorris800 at centurytel.net
Fri Sep 13 18:46:39 CDT 2019


Update: got my SIMH (set console telnet:23) talking to PuTTY in another 
window, via Telnet 127.0.0.1:23.
So it is possible ;)
Now it's time to hook up the actual TTY to the USB-current loop card and see 
what's what!


-----Original Message----- 
From: J. David Bryan
Sent: Friday, September 13, 2019 6:23 PM
To: General Discussion: On-Topic and Off-Topic Posts
Cc: Charles
Subject: Re: Connecting SIMH to teletype via USB

On Friday, September 13, 2019 at 15:42, Charles via cctalk wrote:

> I could use a hint... I have a USB to current-loop (Volpe) interface
> board, and Windows 7 on my laptop does recognize it as COM4 at 110
> baud. So far so good. No problem hooking it up to my ASR-33 Teletype.
>
> Now I'd really like to figure out how to set SIMH to use the 33 as the
> console, so the TTY will be attached to the virtual PDP-8.

Section 3.14, "Console Options" of the "SIMH Users' Guide V4.0" suggests
that:

  set console serial=com4;110-8n2

...should work (though you might need "7e2" or "7o2" instead, depending on
how your Teletype is set up).


> Anything that starts with "set console..." gives a "no settable
> parameters" error.

Does the above also give this error?

                                      -- Dave 


---
This email has been checked for viruses by Avast antivirus software.
https://www.avast.com/antivirus



More information about the cctalk mailing list