Meantime, fixing RX50's.

[Jacob Ritorto]

Sent from my iPhone

> On Nov 19, 2019, at 17:07, Chris Zach via cctalk <cctalk at classiccmp.org> wrote:
> 
> So while trying to figure out this XXDP format error (the FCT Write protect enabled one that's stopping me from formatting an RD54) I spent a bit of time copying the floppy to a backup disk. My RX50 was *very* flakey, throwing errors so I pulled it to see what was up.
> 
> Opened the unit and sure enough: The disk head could use a cleaning, and more important the little pad on the other side came off when I touched it. Apparently the glue holding it in has decayed in the past 30 years. Drat.
> 
> Used isopropyl and q tips to clean the heads, then broke a Q tip in half and put a bit of cyanacryllic glue on the tip, then transferred it to the pad holder, then put the pad back on. Pressed down and breathed on it to give the glue some moisture and waited an hour. Did same to other head.
> 
> RX50 now works perfectly, and I was able to make and boot a backup. So if your RX50 is flakey check to see if the pads are still on the head assembly, it's possible it is loose or fell off (if fell off look around in the RX50 for it, probably in there somewhere)
> 
> Never dull. Now to figure out this write protection issue: I have set the drive to unit 4 (well 3 in the 0-3 world), set the RQDX3 to pins 1 and 2 on the write precomp jumper, and it still comes up but thinks the drive is write protected.
> 
> Drat.