8-Update

[Paul Birkel]

>-----Original Message-----
>-From: cctalk [mailto:cctalk-bounces at classiccmp.org] On Behalf Of Rod G8DGR via cctalk
>-Sent: Sunday, December 16, 2018 2:36 AM
>-To: General Discussion: On-Topic and Off-Topic Posts
>-Subject: 8-Update
>
>Sheesh!! 
>Well what a response. 
>This stems from my (so far) successful major over haul of my PDP-8/e.
>I found one failed 7474 and one failed 8881 – replaced and now working.
>I think I have the rim loader toggled in and will attempt to send a paper tape image from Hyperterm
>Strangely I do have at least three genuine complete 4k memory sets.
>
>The eightstoration will continue.
>
>However I began to think would it be possible to create a close copy of an  8/e out of  modern parts.
>As you all know I make front panels so that’s not a problem. 
>I did manage to copy my (distorted) bezel in resin.
>A friend has been able to 3D print toggle switch leavers that fit and work.
>...

Could you (or your fried) tell us more about "A friend has been able to 3D print toggle switch leavers that fit and work"?
I have need to do the same :-<.  And I don't have a 3D printer, either.

paul