Cassette Interface Assistance

allison ajp166 at verizon.net
Wed Mar 1 05:10:50 CST 2017


On 03/01/2017 01:40 AM, Jim Brain via cctalk wrote:
> On 2/28/2017 2:34 PM, Brent Hilpert wrote:
snippage
> Obviously, given the LM339 issues, this is unworkable in the end, but
> it did get me to realizing some outputs on the LM339, so thanks to
> both of you.
>
> I can plainly see the oscillation on the comparator transitions, so it
> is obvious I need a better comparator.  I'll have to source a few
> different comparator options from Digikey to fill my parts box.
> Suggestions are welcome.
OR  a bit of positive feedback.

>> Using the internal AVR comparator sounds like a better final solution
>> (fewer components), but in devising an
>> input circuit for the AVR you may be running into the same issue of
>> loading a high-impedance source.
> Though it plays into Tonly's notes about my analog understanding (or
> lack thereof), I was so disillusioned by the analog uncertainties that
> I initial focused on the AVR comparator.  By correctly biasing the
> comparator, I was able to get much better results tonight, but the
> lack of any ability to add hysteresis into the design hindered my
> success.  At transition, the signal simply bounces badly.  I tried to
> construct a low pass filter (22pF and 5K6), and some variations, but I
> was not able to overcome.  I then tried to deal with it in SW, but I
> have not yet been successful.  I'll try again, but lack of hysteresis
> is a big issue.
>
Single transistor audio amp before it.

Allison


> Jim
>
>



More information about the cctalk mailing list