COSMAC ELF switch panel v2

[Jim Brain]

On 5/13/2016 1:13 AM, Eric Smith wrote:
> On Thu, May 12, 2016 at 9:38 PM, Jim Brain <brain at jbrain.com> wrote:
>> Not sure if I am completely understanding the concerns with the switches,
>> but:
>>
>>   * I would install the switches and run the top nut out to the very
>>     end, then back the inside nut up to it on the other side of the bazel
>>   * Once all switches are installed, then insert the board and solder.
> Part of the problem is that with the commonly-available switches, the
> push-button has a significantly shorter bushing than the toggles.
But, is it so short that it would not touch the PCB when soldered? If 
not, I think you're OK.
>
Jim