Microvax II hardware not recognized

Douglas Taylor dj.taylor4 at comcast.net
Wed Aug 17 22:37:47 CDT 2016


I've brought up a MicroVax II and installed VMS 5.5-2 on a SCSI2SD disk 
and it is fun to work with.  (I also installed openvms 7.2 without much 
drama)

The problem I am having is that is has a TK50 tape drive and controller, 
but it never has shown up in the device list.  I even swapped in a 
different controller.

The DHV11 did show up initially but has now disappeared from the device 
list.  Did I do this by removing boards and putting them back in?

A RQDX2 board was put back in at a secondary CSR address and that shows 
up (it is connected to an RX50 which shows up in the device list).

Does Autogen recognize new hardware?

Doug




More information about the cctalk mailing list