Serial UNIBUS Repeater?
Paul Anderson
useddec at gmail.com
Mon Jun 15 11:09:50 CDT 2015
BC11-A is flat, guessing 4 inches wide, but you man make nice 90 degree or
what ever angle you need easily.
On Mon, Jun 15, 2015 at 11:06 AM, Mark J. Blair <nf6x at nf6x.net> wrote:
>
> > On Jun 15, 2015, at 09:02, Guy Sotomayor <ggs at shiresoft.com> wrote:
> >
> > I'm not specifically familiar with the 11/730, but what's wrong with
> just cabling up an expansion box "the old fashioned way" using BC11A cable?
>
> Without losing anything else in the already-full rack, I'd need to route
> that cable between two racks. It's already tricky to roll the cabinets back
> into place without rolling over the existing round snakes between the
> cabinets, and I figure that wide ribbon cables would be more cumbersome (or
> is the BC11A round?). I have the system in a tiny room where it's not
> practical to have space behind the racks to get rear access without rolling
> them.
>
>
> --
> Mark J. Blair, NF6X <nf6x at nf6x.net>
> http://www.nf6x.net/
>
>
More information about the cctalk
mailing list