Data I/O 29B

[John Robertson]

On 08/21/2015 5:33 PM, Billy Pettit wrote:
> I have a small batch of Data I/O EPROM burners.  Trying to test them out and ran into a nightmare.  They require a pin family and size parameter.  But in none of the documentation is there any mention of what these values are.  There are some generic pinouts, which are almost useless because Data I/O changed the definition of several pins.
>
> Then the manual says to get your part's timing chart and compare them to 409 pages of timing charts to find the family type!  Nothing is mentioned anywhere on how to calculate size parameter.
>
> There should be a chart or document somewhere that gives the parameters by model numbers like 2516, 2764, etc.
>
> Anyone know of a document like this?
>
> Anyone have experience with the model 29A&B, Model 19, Model 100 gang programmer, etc.
>
> At this point, without better data, these 11 -12 deveces are heading for the scrap pile.  This is the poorest documentation I've ever seen on a piece of test equipment.
>
> Billy Pettit
>
>
There is a good support group for these machine hosted by Alfred Morin 
on yahoo.

To join etc, :

https://groups.yahoo.com/neo/groups/Data_IO_EPROM

Also, I have a bit of Data I/O stuff filed away here (not well sorted 
I'm afraid) from TTL - Tech Tools (mail) List:

FTP site is:ftp://ttl.arcadetech.org/TTL/Test_Equipment


https://pairlist7.pair.net/mailman/listinfo/techtoolslist


John :-#)#