Microcode, which is a no-go for modern designs

Diane Bruce db at db.net
Wed Jan 2 14:09:37 CST 2019


On Wed, Jan 02, 2019 at 02:37:44PM -0500, Paul Koning via cctalk wrote:
> 
> 
> > On Jan 2, 2019, at 2:31 PM, Chuck Guzis via cctalk <cctalk at classiccmp.org> wrote:
> > 
> > On 1/2/19 10:44 AM, Guy Sotomayor Jr wrote:
> > 
> >> Also, recall that there are different forms of micro-code: horizontal
> >> and vertical.  I think that IBM (in the S/360, S/370, S/390, z/Series)
> >> uses the term micro-code for horizontal micro-code and millicode
> >> for vertical microcode.
> > 
> > On the CDC STAR-100, "microcode" as such was a relatively recent concept
> > and the designers went overboard, mostly because of an ill-defined
> > customer base (hence, BCD and other commerical-class instructions, like
> > translate, edit and mark, etc.).  The STAR is basically a RISC-type
> > vector architecture with a pile of microcoded instructions bolted on.
> > ...
> > For a compiler writer, or even an assembly coder, this was more of a
> > problem--which combination of instructions could be used to the greatest
> > effect?  And why do I have to have the hardware manual on my desk to
> > look up instructions?
> 
> That reminds me of the Motorola 68040.  I used that at DEC in a high speed switch (DECswitch 900 -- FDDI to 6 Ethernet ports).  When studying the instruction timings, I realized there is a "RISC subset" of the instructions that run fast, a cycle or so per instruction.  But the more complex instructions are much slower.  So the conclusion for a fastpath writer is to use the RISC subset and pretend the fancy addressing mode instructions do not exist.


Which then reminds me further of the Coldfire processor which
*did* remove the more complex instructions from the chip!


> 
> 	paul
> 

Diane
-- 
- db at FreeBSD.org db at db.net http://artemis.db.net/~db


More information about the cctech mailing list