CGA card (Mitsubishi Electric) with 192K RAM?

Jules Richardson jules.richardson99 at gmail.com
Sun Sep 6 15:27:32 CDT 2020


Digging through old PCs, on a battery-removal spree... came across a Sperry 
3070 XT-a-like (I wouldn't quite call it a clone, it's a bit goofy) which 
has a Mitsubishi Electric system board, RAM expansion, and video hardware.

The video hardware is... odd. It's actually two full-length boards, joined 
with a large IDC cable along the top edge as well as via the ISA bus. The 
only "complex" IC is a 6845 - other than that it's masses of TTL.

Output is via a DE9, and pinouts seem consistent with CGA (15.7KHz on pin 
8, 60Hz on pin 9, 3/4/5 at TTL levels and 1/2 ground). There's also an RCA 
jack on the backplate, and that 6845 IC... it all seems very CGA-like, 
except that total video memory is 192KB.

CGA was normally 16KB, I believe. Hercules and EGA 64KB, although I think 
toward the end of EGA's existence there was a 192KB option. Physical 
outputs aren't consistent with EGA's two bits per pixel, though.

Does this ring any bells with anyone? I don't know why it needs such a 
large amount of RAM if it's stuck with CGA capabilities. One board is 
branded WECD10 and the other WECD11, but there's no "model" or anything.

cheers

Jules






More information about the cctalk mailing list