GW-DEC-1: A New DEC Prototyping Board

systems_glitch systems.glitch at gmail.com
Fri Aug 16 08:59:16 CDT 2019


Paul,

I've got a board house I usually use, but if I can find a shop in the USA
that will do hard gold plating and provide a comparable cost-per-board, I'd
certainly switch!

Thanks,
Jonathan

On Fri, Aug 16, 2019 at 12:55 AM Paul Anderson <useddec at gmail.com> wrote:

> Hi Jonathan,
>
> If you are looking for someone to make the boards, I know someone in CA.
> I'll try to dig up his contact info this weekend.
>
> Paul
>
>
> On Wed, Aug 14, 2019 at 7:14 PM systems_glitch via cctalk <
> cctalk at classiccmp.org> wrote:
>
>> Connor Krukosky and I have been working on laying out a new quad-height
>> DEC
>> protoboard, which can also be sheared down into a dual-height board. Full
>> announce on the VC Forums:
>>
>>
>> http://www.vcfed.org/forum/showthread.php?71177-GW-DEC-1-A-New-Quad-Height-DEC-Prototyping-Board&p=582892#post582892
>>
>> These should be available within a month or so. I'll be putting up a
>> preorder soon to gauge interest in the production run, which as usual will
>> have hard gold plating on the edge connectors. I haven't gotten a quote
>> for
>> the cost, but I expect them to be $30-40 each for production boards.
>> They'll be available at VCF Midwest as well as online!
>>
>> Thanks,
>> Jonathan
>>
>


More information about the cctalk mailing list