Assessing Plastibands for QIC Tension Band Replacement

systems_glitch systems.glitch at gmail.com
Mon Jun 18 15:44:12 CDT 2018


I'd seen your posts earlier, as luck would have it I've also been going
through some QIC tapes lately. I've been working with a US-based custom
rubber products manufacturer on finding replacement drive bands. Nothing to
report back yet, first round of samples felt like the right material but
were the wrong size (my goof, I think).

Thanks,
Jonathan

On Thu, Jun 14, 2018 at 4:26 PM, jacob--- via cctalk <cctalk at classiccmp.org>
wrote:

> On Mon, 4 Jun 2018, AJ Palmgren via cctalk wrote:
>
> If anyone is interested, I just published a few videos showing my testing
>> of PlastiBands for QIC Tape Cartridge replacement.
>>
>> https://youtu.be/irOrR-ZYwjw
>>
>> and
>>
>> https://youtu.be/GVsYHLvCvZY
>>
>> A special thank you to CuriousMarc, Al Kossow, and Chuck(G) for their
>> help,
>> leadership and inspiration in this area!
>>
>
>
>> And my page dedicated to QIC Tension Bands...
>>
>> http://qicreader.blogspot.com/p/drive-belts.html
>>
>> As always, I welcome feedback, and hope this is of value to some here.
>>
>
> Have just been through 25 qic tapes of amiga bbs backups , after 23 years
> of being stored in a attic, the majority of tapes was in good order, only 3
> had bad tension band.
> A single 3M had lost all tension,causing  slipping, and had gotten tangled
> up, turned out to the the hardest of the lot to read, after replacing
> the band and untangling it.
>
> Your site was really helpful, had my doubt but your videos showed it wasnt
> that hard after all to replace and untangle those tapes.
>
> Restored 1.7gb data, mix of diavolo backup and amiback2 from two differnt
> amiga bbs .
>
>
> --
> Jacob Dahl Pind | telefisk.org | fidonet 2:230/38.8
>
>


More information about the cctalk mailing list