H960 blank panel clips

Pete Turnbull pete at dunnington.plus.com
Wed Jul 29 09:05:56 CDT 2015


On 29/07/2015 14:11, Vincent Slyngstad wrote:
> From: Pete Turnbull: Wednesday, July 29, 2015 2:57 AM
>> Firstly, to add a small fillet to the junction of post and flat

> Are you referring to the junction of the post and the block?  That would
> be easy enough to do (though tedious in SketchUp).

Yes, that's where I meant.

> Or are you referring to the bottom edges of the slots?

No, that shouldn't matter since it's in slight compression.

> One concern that I had was that the new design might end up trying to
> ovalize the (brittle) socket in the mating panel, since the new posts
> are only really compressible in one axis.

I doubt that matters much either, because it's the posts that break, not 
the sockets.

-- 
Pete

Pete Turnbull


More information about the cctalk mailing list